Two-bottle carrier generator
The opposite of a stacked, bolted build. It has one stadium-shaped tub with round pockets carved into it, and one handle that grows out of it: a stem tapering up from a flared foot into a rounded-triangle loop. The handle prints flat for strength along its length and drops into a hidden mortise, held by one M4 screw from underneath, so no hardware shows. The checks confirm the bottles lift and tip out past the loop, a full hand fits the grip, and the stem carries two full bottles swinging at 2 g against the material's allowable stress.

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.
What Loftsmith can do
See what Loftsmith designs
Straight from the Loftsmith Workshop, every print check passed. Need a part this page can't make? Describe it and Loftsmith designs it for you.
Specs at the default size
Measured from the actual build on a Bambu Lab A1 in PLA. Every number updates live when you drag a slider above.
- Overall size
- 201 × 76 × 248 mm
- Parts
- 2
- Filament
- 133 g
- Print time
- 3 h 5 min
- Build plates
- 2
- Supports
- None needed
Engineering checks
- Bottles stand free in their pocketsoverlap -0.00 mm³ with a 69 mm bottle; 1.25 mm clearance
- Bottle lifts out and tips past the loop5 sampled poses (lift 31 mm tipping to 10 deg, then 22 deg): worst overlap 0.00 mm³
- Full hand fits the loop85 x 30 mm grip envelope, overlap 0.00 mm³
- Stem carries two full bottles0.4 MPa at the 20 mm neck with 2 g swing; PLA allows 16.7 along the layers
- Handle fits the bed flatflat 138 x 237 mm, set diagonally if longer than the bed
Adjustable sizes
| Setting | Default | Range |
|---|---|---|
| Bottle diameter | 68 mm | 55–80 mm |
| Bottle height | 170 mm | 140–190 mm |
| Full bottle weight | 0.8 kg | 0.3–1.2 kg |
Parts list
| Part | Qty | Size (mm) | Filament | Time |
|---|---|---|---|---|
| tub | 1 | 201 × 76 × 36 | 86 g | 1 h 59 min |
| handle | 1 | 138 × 237 × 16 | 46 g | 1 h 6 min |
How to make it
- Measure your bottles' diameter and height and set their full weight.
- Print the tub upright and the handle flat on its back.
- Set an M4 heat-set insert in the tenon and screw the handle in from underneath.
Print tips
- PETG for a carrier that lives near a fridge or outdoors.
- The handle's strength runs along its layers, so keep it flat on the bed.
FAQ
How much can it carry?
The stem check uses your bottle weight at a 2 g swing and the selected material's allowable stress. That is a design estimate, so load-test your print before trusting it with glass.
Need a shape that isn't in the catalog? Describe it in your own words with text to CAD

Comments