From the Loftsmith Workshop
Christmas tree collar, hinged panels sized to your stand
Keeps pets, toddlers and wandering socks away from the tree stand and its water. A ring of lattice panels folds around the base, and a little star sits on top of each post. Set your stand's width and the height you want.
24 parts · 576 g · 176 × 10 × 238 mm
Remix of Print-in-place hinge tester
Ask for the sizes you want to tweak, e.g. “make the width adjustable”.
How to print it
Parts
- panel ×12 · PLA (deep red) · Flat, inner face down; the corner knuckles lie on the bed and the arched top, moulding and rounded opening edges face up
173 x 220 x 10 mm at the defaults; about 44 g and 63 min each (2 walls, 15% infill). Every panel is identical, and the default lattice leaves 54% of the panel face open. PLA because the collar is a stiff indoor decoration away from heat.
- pin ×12 · PLA (gold) · Lying down on its flat side, set diagonally on the plate; the star cap lies flat on the bed
4.8 mm pin with a star cap, about 4 g and 9 min each. The cap bar rests on the top knuckle, so the pin hangs by gravity through all 5 knuckles of its joint.
Print settings
- Layer height
- 0.2 mm
- Walls
- 2
- Infill
- 15%
- Supports
- None
- Notes
- At the defaults the whole set (12 panels and 12 pins) is about 599 g and 14 h 54 min at 2 walls and 15% infill, one panel per plate on a 256 mm bed. Other sizes and the stars and circles patterns change the total, so check the Print tab for the grams and time at your settings before you start. Print
Assembly
- Measure your stand at its widest point, legs included, and set Stand width. Set Collar height to clear the lowest branches.
- Print the panels and pins (12 of each at the defaults). Test one pin in a joint between two panels first: if it binds, raise Pin clearance by 0.05-0.1 mm and reprint.
- Stand two panels side by side with the moulding facing out, mesh their corner knuckles and drop a pin in from the top. The star sits above the post and faces out.
- Join the rest of the panels the same way into a chain, keeping one joint open.
- Wrap the chain around the stand, bring the two free ends together and drop in the last pin. The ring closes as a regular polygon with the set gap all round the stand.
- To reach the water reservoir, lift one pin and swing that panel outward. For storage, pull all the pins and stack the panels flat (120 mm high at the defaults).
Good to know
- The fits, clearances and pin strength are checked in the Loftsmith engine, not on a real printer. Print one joint first and adjust Pin clearance if needed.
- The default lattice is 54% open, so the stand shows through the panels. The stars and circles patterns have smaller openings.
- The panels are sized and checked for a 256 mm bed. At the defaults each panel is 173 x 220 mm, which does not fit a 180 mm bed.
- If a panel would not fit a 256 mm bed, the panel count is raised automatically above the slider value (for example, an 800 mm stand gets at least 12 panels).
- The pins are held down by gravity only. A sideways kick cannot lift them out, but pulling the collar up by its top can lift a pin, so move it by the base.
- This is decoration that surrounds the stand. It is not a barrier for pets or children and does not hold the tree up.
- PLA softens at about 55 °C, so keep the collar away from heaters and hot lamps.
- The full set is a large print: about 599 g and 14 h 54 min at the defaults. Check the Print tab for other sizes and patterns.
Comments