From the Loftsmith community

Cuscinetto a sfere Ø40×10

A ball bearing you can print in one go, for a spinning job where a plain hole would grind. The balls sit in a ring between two races, and you can see them through the gap. Change the bore and the thickness to match your own shaft and space.

3 parts · 7 g · 40 × 40 × 10 mm

Orange ball bearing with an inner ring, outer ring and a ring of small balls between them, on a clear shaft
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • outer-ring · PLA · Appoggiato su una faccia piana, nessun supporto
  • inner-ring · PLA · Appoggiato su una faccia piana, nessun supporto
  • balls · PLA

    13 sfere stampate in sede, dentro la gola, insieme agli anelli

Print settings

Layer height
0.16 mm
Walls
3
Infill
15%
Supports
Nessuno
Notes
Stampa i tre pezzi insieme, con l'asse in verticale.

Good to know

  • Le 13 sfere sono corpi separati di proposito: è un cuscinetto stampato già montato, e il controllo conferma che restano tutte intrappolate. Per questo il report segnala pezzi staccati e poco contatto col piano, e va bene così.
  • Il foro da 15 mm è una stima: se ti serve un altro albero, cambia il cursore Diametro foro.
  • Non l'ho provato fisicamente. Dopo la stampa fai girare l'anello a mano per liberare le sfere. Se resta duro, aumenta il Gioco sfere.

Comments