From the Loftsmith community

Spotlight bar clamp with base

Gives a spotlight a steady seat on a rectangular bar, so it isn't balanced on something that wasn't built to hold it. A square plate with a screw hole in each corner sits on a clamp that wraps the bar. Change the bar's height and width to match your own tube.

2 parts · 108 g · 167 × 155 × 58 mm

Flat square plate with four corner holes on a small clamp that wraps a rectangular bar
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • base-clamp-top · PLA · Base face down on the bed, clamp pointing up (printRotate 180 flips it from the assembled pose)

    Hex pockets for four M6 nuts

  • clamp-bottom · PLA · Split face down (printRotate 180)

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%, or 25% with 4 walls for more bolt grip
Supports
None

Hardware

  • 4 × M6 x 25 mm socket bolts · Heads sit in counterbores under the lower half
  • 4 × M6 hex nuts · Press into the pockets in the top half

Assembly

  1. Press the four M6 nuts into the pockets in the top half.
  2. Set the clamp over the bar.
  3. Bring the lower half up from below, drop in the bolts and tighten evenly with a 5 mm hex key.

Good to know

  • I assumed a 3 kg light and 2 mm bar corners. Please check them against yours.
  • Strength figures are estimates for PLA. PLA softens around 55 °C, so use PETG if the light gets hot or sits in the sun.
  • Test the fit on your bar before the full print. If it's tight, raise the Opening clearance slider.

Comments