From the Loftsmith community

XLR + 1/4" jack project box

A small home for the guts of a homemade audio gadget. The front has a square pad with a big round hole for an XLR socket, plus a smaller hole beside it for a 1/4" jack, and a lid closes it up. Change the hole sizes and the depth to suit your parts.

2 parts · 52 g · 82 × 61 × 53 mm

Dark rounded box with an orange lid and a large round hole and a small round hole on the front
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • box · PLA

    Print open side up, no supports

  • lid · PLA

    Print top face down, lip up

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None

Hardware

  • XLR panel-mount socket (D-size) with M3 screws · The screws cut their own thread in the printed pilots; the connector's flange covers the hole
  • 1/4" panel jack with nut · Fits a 9.5 mm hole; the wall is 3.2 mm thick, so check the thread reaches

Good to know

  • Hole sizes and screw spacing are typical values. Test-fit your own connectors and adjust the sliders on the Adjust tab.
  • The lid's friction fit is untested: tune the Lid fit gap slider if it's too tight or loose.
  • The lid report flags ~3% small overhangs at its chamfered edge, with almost no support needed. If your slicer adds supports there, turn them off.

Comments