From the Loftsmith community

Hose drain jetter nozzle

For clearing a slow drain with nothing but a garden hose. The nose slips into the pipe while a ribbed collar gives you something to grip as you thread it on. Change the jet sizes, the rear jet angle or the nose length to suit your drain.

1 part · 14 g · 36 × 36 × 64 mm

Tapered nozzle with a ribbed collar and a short nose, shown beside a pipe and hex fitting outline
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • jetter-nozzle · PLA

    Print nose-down so it needs no supports.

Print settings

Layer height
0.16 mm
Walls
4-6
Infill
20-100%
Supports
None (print nose-down)
Notes
Use more walls or higher infill for a watertight part. Print slowly for clean threads.

Hardware

  • Rubber garden hose washer (3/4") · Drop it into the seat before screwing on.

Assembly

  1. Drop the rubber washer into the seat.
  2. Hand-tighten the nozzle onto the hose end.
  3. Feed it into the drain and turn the water on slowly.

Good to know

  • Test the thread fit on a short print first. Hose threads vary, so adjust the Thread clearance slider if it binds or leaks.
  • PLA softens at about 55 °C, so use cold or warm water only. Print in PETG for hot water.
  • The report flags thin ledges along the rear jet channels. They are inside the drilled holes and don't affect the outside surface.
  • Rear jet thrust was checked by jet area only, not by a flow test.

Comments