From the Loftsmith community

Galaxy S23 Ultra TPU case with almond evil eye

A snug case for a Galaxy S23 Ultra, with a tall slot at the back so the camera lenses see out freely. The side buttons and bottom ports have their own cutouts, and a small raised lip wraps the screen. Change the camera slot or wall thickness to suit you.

2 parts · 37 g · 83 × 167 × 13 mm

Dark phone case seen from the back with a tall rounded camera slot and side button cutouts
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • case · TPU 95A (black) · Back flat on the bed, open side up

    Prints over the eye, so leave the eye on the bed

  • evil-eye · PETG (blue) · Flat on the bed, in the same spot as its pocket

    Two pieces: the almond and the loose iris ring. Print first and leave both on the bed

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None
Notes
Print the blue PETG eye first and leave both pieces on the bed. Then load the black TPU 95A HF and print the case at the same position. Print the TPU slowly on a textured PEI plate.

Assembly

  1. Print the blue eye (almond and iris) and leave it on the bed without touching it.
  2. Switch to black TPU and print the case in the same spot, right over the eye.
  3. Peel the case off with the eye locked in.
  4. Put the phone in top end first, then stretch the lip over the bottom corners.

Good to know

  • The eye prints as two loose pieces on purpose. The 1 mm black outline you asked for goes all the way round the iris, so the iris can't be joined to the almond. Leave it alone on the bed until the TPU covers it.
  • The 'phone goes in' check fails on purpose: a solid phone can't pass the lip in the 3D view, but the real TPU lip stretches over it.
  • The slicer may want support under the eye pocket, but you don't need it: the PETG printed underneath holds that roof up, so turn supports off.

Comments