From the Loftsmith community

Compass set tray insert

Gives each piece of a drawing set its own spot, so nothing rattles around in the case. Long and short pockets are cut into a flat tray, with a narrow channel running the length for the longest tool. Change the width, length or pocket depth to match your case.

1 part · 96 g · 62 × 332 × 16 mm

Long flat dark tray with shallow fitted pockets and one long channel down its length
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • Insert tray · PLA · Flat, pockets up

    332 mm long, so on the P1S it prints on the diagonal. You can also shorten it with the Tray length slider.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
none
Notes
One filament. Add an accent colour on the pocket floors if you want one.

Good to know

  • All sizes are estimated from the photo. Measure your case and the pieces, then adjust the sliders.
  • The tray is 332 mm long, longer than the 256 mm bed. It only fits if printed on the diagonal, which is tight, so shorten it or split it if the slicer says it doesn't fit.

Comments