From the Loftsmith community

Bubble alphabet letters

A full A to Z set of chunky flat letters for spelling out names, lining up on the fridge or playing sounds-out games on the floor. Each one is a single piece with rounded edges, laid out ready to print in one go. Change the letter height or the thickness to suit little hands.

26 parts · 62 g · 251 × 141 × 11 mm

Twenty-six chunky rounded letters from A to Z laid out in four rows, in bright colours
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • letter-A … letter-Z (26 parts) ×26 · PLA · Flat back on the bed, domed side up

    Every letter prints with no supports. Spread them over two plates on the Print tab, since the whole set is wider than the A1 bed.

Print settings

Layer height
0.16 mm (smoother domes)
Walls
2
Infill
15%
Supports
None
Notes
Use a different filament colour for each plate, or switch colours between letters, to get a rainbow set.

Good to know

  • At the default puffiness, the small opening of the G and the hole in the O close up a bit. If you'd like them more open, turn Puffiness down a little on the Adjust tab.
  • The letters are small enough to swallow, so keep them away from toddlers.
I printed this Remix

Comments