From the Loftsmith community

Flat two-cable holder

Keeps two cables running side by side instead of tangling on your desk. Each one snaps into its own round seat and stays put, with the cables held parallel. Change the cable size and it fits your own wires, thin or chunky.

1 part · 2 g · 12 × 14 × 28 mm

Small orange block with two round notches holding two parallel cables
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • clip · PLA · Lying on its side so the C arms print flat and flex along the layers

    34 x 33 x 14 mm

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None
Notes
Print on its side.

Assembly

  1. Push the clip onto the desk edge.
  2. Press the cable into the ring from the side until it snaps in.

Good to know

  • The build report flags the clip overlapping the desk ghost by 14 mm³. That is deliberate: it is the 0.4 mm grip-bump squeeze that holds the clip on.
  • I guessed 25 mm for the desk thickness. Measure yours and set the Desk thickness slider before printing.
  • The cable press-in and the clip's hold on the desk have not been tested on a real print. PLA can crack if you flex the arms often, so try PETG if you plan to take it on and off a lot.
I printed this Remix

Comments