From the Loftsmith community

Galaxy S25 cover for car holder

A slim case for a Galaxy S25 that lets it ride on a magnetic car mount. There's a round steel ring recessed into the back, and a tall slot on the side keeps the camera clear. Change the phone width and thickness to fit your own handset.

1 part · 28 g · 73 × 150 × 11 mm

Phone case with a round ring on the back, a tall camera slot and a small cutout at the bottom edge
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • phone cover · PLA

    Print back-down, no supports.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None
Notes
Back face down on the bed.

Hardware

  • Steel ring/plate (from your car holder kit) · About 56 mm across, 0.7 mm thick, with a 5.5 mm ring width. Stick it into the recess inside the back.

Assembly

  1. Stick the steel ring into the round recess inside the back.
  2. Snap the phone in, bottom edge first, so the walls flex over the lip.
  3. Press the cover onto the car holder's magnet head.

Good to know

  • The camera slot, button slot and ring position are estimated from the S25 layout and not test-fitted. Print the cover and tweak the sliders on Adjust if anything is off.
  • The snap-in lip is at the edge of PLA's safe flex limit. If it feels tight, raise Fit gap per side a little, or print in PETG.
  • Magnet holding force through the 1.3 mm back is untested, so check it before you drive.
  • If your holder is a clamp or a ball-joint type, tell me and I'll change the back.

Comments