From the Loftsmith community
Allen key organiser
Gets your Allen keys out of the loose bundle in the drawer. Each key stands in its own hex socket, smallest to largest, with the size marked beside it so you grab the right one first time. Change the socket clearance if yours sit too snug or too loose.
1 part · 87 g · 200 × 50 × 46 mm
Loading the 3D view
Loading the 3D view
No adjustable sizes
Ask for the sizes you want to tweak, e.g. “make the width adjustable”.
How to print it
Parts
- stand · PLA · Flat on its base, sockets pointing up
No supports needed.
Print settings
- Layer height
- 0.16 mm (cleaner numbers)
- Walls
- 3
- Infill
- 15%
- Supports
- None
- Notes
- To make the numbers stand out, pause or swap colour at the label depth, or fill them in with a paint marker.
Assembly
- Print it, then drop each key into its labelled socket, long arm down, short arm pointing to the back.
Good to know
- Key lengths are typical values, and the socket fit is set to 0.35 mm of play. If your printer runs tight and the small keys won't go in, raise the Socket fit clearance slider on Adjust. If keys rattle, lower it.
- The analyzer flags a few thin ledges at the bottom of the engraved numbers. Those are just the floors of the letters and won't affect how it prints.
Comments