From the Loftsmith community

7×5 grid insert, 6 pieces for 200 mm bed

Turns one big open box into 35 neat little squares, so small parts and loose bits stay where you put them. It's split into 6 pieces, so each one prints on a small 200 mm bed, then they sit together inside the box. Change the square size and the box length and width to match your own.

6 parts · 484 g · 404 × 277 × 44 mm

Rectangular grid of seven by five square compartments with small tabs along the edges
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • grid-front-left · PLA · Flat on the bed, open side up

    4 × 3 squares

  • grid-front-right · PLA · Flat on the bed, open side up

    3 × 3 squares

  • grid-back-left · PLA · Flat on the bed, open side up

    4 × 2 squares

  • grid-back-right · PLA · Flat on the bed, open side up

    3 × 2 squares

Print settings

Layer height
0.2 mm
Walls
2
Infill
15% (walls are thin, so they print nearly solid anyway)
Supports
None
Notes
One piece per plate; a brim helps the long thin walls stay down.

Assembly

  1. Drop the two front pieces into the box against the front wall.
  2. Drop the two back pieces in behind them; the shared walls sit side by side and the tabs hold everything in place.

Good to know

  • I assumed the box is 16 × 11 inches inside. Measure it and adjust the Box sliders before printing if it's different.
  • Where the pieces meet, the walls are doubled up (3.2 mm). That's normal and makes those squares look the same size.
I printed this Remix

Comments