From the Loftsmith community

Emmy's dragon & blossom screw-on lens cap

Gives your lens a cap that's clearly yours, so it never gets mixed up on a shared camera bag. A raised pink dragon, blossom branch and name sit on the black top, and the ribbed rim helps you get a grip. Change the thread size to fit your lens.

1 part · 12 g · 63 × 63 × 9 mm

Round black screw-on lens cap with a pink dragon, blossom branch and name raised on top
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • cap · PLA

    Print face down so the artwork is on the bed.

  • artwork · PLA

    Pink layer, printed inside the cap with a colour change.

Print settings

Layer height
0.12 mm for crisp artwork (0.16 is fine)
Walls
3
Infill
15%
Supports
None needed; the chamfered flange and clip catch print at about 45° or less. Add a brim if the clips lift.
Notes
Pink on filament 2, plum on filament 1.

Assembly

  1. Press the cap straight onto the lens front. The clip legs flex in and the catch bumps snap behind the lens lip.
  2. Pull it straight off to remove.

Good to know

  • I haven't tested the fit on your lens. If it is loose or tight, change the Clip catch bump slider (0.2 mm now) or Fit diameter, and print a quick test.
  • The report still lists some small thin ledges near the dragon's spines and about 1 g of possible support on the 45° flange and catch. Check the first print and add a brim or tree support if needed.
  • The name strokes are about 0.7 mm wide, so print at 0.12–0.16 mm layers and check the lettering.
I printed this Remix

Comments