From the Loftsmith community

nRF24L01+PA/LNA case

A small box for the nRF24L01+PA/LNA radio board, so it stops dangling by its jumper wires. The lid sits on top, there's a notch in one end for the antenna, and there's room underneath for the plugs. Change the board length and width to match yours.

2 parts · 11 g · 42 × 20 × 32 mm

Dark rectangular box with an orange lid and a small notch at one end where an antenna pokes out
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • base · PLA

    Print floor down, no supports.

  • lid · PLA

    Print top face down, no supports.

Print settings

Layer height
0.2 mm
Walls
2-3
Infill
15%
Supports
none

Good to know

  • The module's size and the SMA elbow height (about 8 mm) are estimated, since the photo had no measurements. Measure your board and adjust the Board length, Board width and Board clearance sliders if the fit is off.
  • The lid is a friction fit with 0.2 mm clearance. I haven't test-printed it, so you may need a small tweak.
  • The build report still shows a thin-ledge warning, which is the flat rim of the lid lip, and a 'blocked' Open animation where the lid just touches the base. Both are intended.

Comments