From the Loftsmith community

Tiered Vanity Organizer

Gives brushes, lipsticks and small bottles their own spot on your vanity instead of one jumbled pile. The front steps up in tiers with slots, a row of small holes sits at the base, and round wells and a tall square cup hold the rest. Change the width or the hole size to suit your kit.

2 parts · 866 g · 240 × 253 × 175 mm

Stepped organizer with a row of small holes, slotted tiers, round wells and a tall square cup at the back
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • riser · PLA · Flat bottom down, upright

    Three tiers, each with an 8 mm front lip, and 4 lipstick holes. Dovetail keys on the back.

  • tower · PLA · Upright, flat bottom down

    Two can wells, a comb slot, a tall cubby, and dovetail slots in the front face.

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
Tree supports for the riser's lips if your slicer asks for them; none for the tower

Assembly

  1. Print both parts upright.
  2. Lower the tower straight down onto the two dovetail keys on the back of the riser.

Good to know

  • The riser's report still shows a few overhangs and two thin ledges. Turn on tree supports for the riser's lip areas and check the first print.
  • The dovetail fit uses 0.3 mm clearance. Test it with a short print of the key and slot first.

Comments