From the Loftsmith community

1:7.5 4WD canopy model

A small-scale canopy for a toy or display 4WD, so the back of your ute has something to hide under. The rear door is hinged along the top with two pairs of little tabs, and each side has a shallow recessed panel. Change the scale or the real-world width, length and height to match your vehicle.

2 parts · 248 g · 160 × 243 × 113 mm

Boxy grey canopy with a dark hinged rear door and a recessed panel on the side, sitting on a flat base plate
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • canopy · PLA

    Print roof-down, no supports.

  • rear-door · PLA

    Print with the inner face down, no supports.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None

Hardware

  • 2 × 1.75 mm filament offcuts · Hinge pins, about 27 mm each. Heat one end to mushroom it.

Assembly

  1. Put a short length of filament through each hinge set, with the door's knuckle between the two canopy knuckles.
  2. Mushroom both ends of each pin with a lighter or soldering iron so it can't slide out.

Good to know

  • The knuckles and 2 mm pin holes are small. Print the door first as a test and check that it swings freely, and adjust the 0.4 mm gaps if it binds.
  • The report flags a few thin ledges on the canopy, and the door has flat faces. They are cosmetic, and I haven't gone back to smooth them.
  • The window and latch details are shallow recesses. Nothing is functional at this scale.

Comments