From the Loftsmith community

Credit card cover

Keeps a card from getting scuffed and scratched in a bag or pocket. The card slides in through a gap on one short end, and the window in the front still shows its face. Change the slot thickness and the side play to match your own card.

1 part · 12 g · 91 × 59 × 4 mm

Flat rounded rectangle frame with a large window and a notch on one short edge
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • card cover · PLA · Photo face down on the bed, exactly as modelled

    A textured or smooth PEI plate gives the front its finish

Print settings

Layer height
0.12 mm (thin part, cleaner slot)
Walls
3
Infill
20%
Supports
None
Notes
The 5 mm rim ledges over the card slot print fine without supports. Keep the part cooling fan at full.

Assembly

  1. Slide the card in through the notched end with the card's face toward the photo side.
  2. To take it out, push on the card through the thumb notch until it rides over the little ridge.

Good to know

  • The Ishikawa photo isn't on it yet. Attach the image and I'll add it as a flush multi-colour picture (AMS) or a raised two-colour relief.
  • The card's hold is a light friction stop, so test it with your card. If it feels loose or tight, change the Card slot thickness slider on the Adjust tab (go up a little for embossed cards).

Comments