From the Loftsmith community

Shun Premier sheath with traced logo

Keeps the edge of your Shun Premier covered in the drawer instead of loose among the spoons. It's a slim, flat sheath with the Shun mark traced into the face and two small red tabs for the grip bar. Change the blade length, width and thickness to match your knife.

2 parts · 65 g · 222 × 63 × 9 mm

by Dean

Flat black knife sheath with a traced logo and two red tabs, beside a round grip bar
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • sheath-front · PETG · Split face down, logo facing up

    TPU grip bars and edge guard print with it on filament 2

  • sheath-back · PETG · Split face down (flip 180°)

    TPU grip bars and edge guard print with it on filament 2

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
Minimal; split face down
Notes
Filament 1 PETG (black, body). Filament 2 TPU 95A (red, grip bars and edge guard). Expect a prime tower.

Assembly

  1. Print both halves split-face down with TPU on filament 2.
  2. Check the knife slides in a dry fit.
  3. Glue the split faces together with the blade slot aligned.

Good to know

  • The grip bars sit at 0 mm squeeze, so they don't pinch the blade yet; raise the Grip bar squeeze slider if the knife feels loose. I haven't tested the grip.
  • The Use it animation reports a 0.011 mm³ touch between the knife and sheath at one point, which is far too small to matter. The report also warns of overhangs and small ledges where the TPU meets the PETG; I didn't remove them, so expect some support or small surface lines.
  • PETG and TPU bond, but the two halves need gluing along the split. The logo's fine tail strokes may print softly, so test it first.
I printed this Remix

Comments