From the Loftsmith community

Cue aim tool, holes lowered 3 mm

Helps you line up a pool or snooker shot by eye. Slide your cue through one of the five round holes in the upright disc and check where it points. The disc stands on its own round base with a gap for the cue. Change the hole size to suit your cue.

1 part · 13 g · 57 × 55 × 57 mm

Green upright disc with five round holes on a half-round base, a pale cue passing through the centre hole
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • cue-aim-tool · PLA · Base down, as supplied

    Reprint needed: the hole positions differ from version 4.

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
Only under the round hole tops if the slicer asks for them (about 2 g).

Good to know

  • The bottom hole still just breaks through the foot of the disc. It is a small opening about 5 mm wide at the base, and the part is still one piece.
  • The skin-defect and overhang warnings come from your original model's base and hole edges, which I left alone. I haven't printed or fit-tested anything.

Comments