From the Loftsmith community

Keyword die

A word die for when the group can't decide what to write, draw or act out next. Each face has a different word pressed into it, and the corners are rounded so it rolls nicely in your hand. Change the size and how deep the lettering goes.

1 part · 10 g · 30 × 30 × 30 mm

Dark navy rounded cube with a different word engraved on each visible face
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • die · PLA · Sitting on any face (Ward down is fine)

    Add a second colour with the Two-colour inlay switch on the Adjust tab (needs an AMS).

Print settings

Layer height
0.12 mm (crisper letters)
Walls
3
Infill
15%
Supports
None
Notes
The rounded bottom edges and the word on the bottom face are tiny overhangs that print fine without supports. Turn on ironing for the top face if you want it extra smooth.

Good to know

  • The bottom edges are rounded, so they may look a little rougher than the top. That's normal for printed dice and doesn't need supports.
  • For the crispest letters, paint the cut-in words with acrylic and wipe off the surface, or use the two-colour inlay.
I printed this Remix

Comments