From the Loftsmith community

18 mm edge-drilling jig, round side guides + end guide

Gets dowel and screw holes straight into the edge of a board, so you're not trusting your eye on a drill. Three guide holes in different sizes sit along the top, with more through the side and the end. Set the board thickness and the spacing to match your own stock.

1 part · 36 g · 94 × 38 × 40 mm

Orange block with three round guide holes on top, more on the side and end, and 18MM marked on the front
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • jig · PETG · Legs down, closed top face up

    Print with the legs down; press the bearings in by hand or with a vise.

Print settings

Layer height
0.2 mm
Walls
4
Infill
25%
Supports
None
Notes
The side pockets are teardrop-shaped so they bridge cleanly.

Hardware

  • 2 × 608 bearing (8 mm bore, 22 mm OD) · Only if you use the 8 mm guides on both sides and the top
  • 3 × 627 bearing (7 mm bore, 22 mm OD) · One for the top and one for each side
  • 3 × 625 bearing (5 mm bore, 16 mm OD) · One for the top and one for each side

Good to know

  • The bearing pocket fit is untested. Print it and adjust the 'Bearing pocket allowance' slider if the bearings are too tight or too loose.
  • The slicer may still report minor thin ledges near the engraved text and a little overhang around the side pockets. Neither should need supports, but check the print preview.

Comments