From the Loftsmith community

Compact 1-inch PEI scraper, 45° bevel

Lifts a finished print off a PEI plate without gouging it. The flat blade has a shallow bevel that slips under the edge, and the long rounded handle gives your hand something to push on. Change the blade width or bevel angle to suit your plate.

1 part · 20 g · 145 × 22 × 25 mm

Long rounded orange handle with a thin flat beveled blade at one end
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • Scraper · PLA · Lying on its side, with the flat 40 mm blade face on the bed. No supports.

    Print with 4 walls so the blade is solid.

Print settings

Layer height
0.2 mm
Walls
4
Infill
20%
Supports
None
Notes
Print on its side. For extra toughness use PETG.

Good to know

  • The analyzer flags the 0.8 mm flat edge at the tip as a thin ledge. That edge is the flat scraping end you asked for, so I kept it.
  • PLA is stiff, so use a gentle push and slide it in at a low angle, since it hasn't been physically tested. If you want more give, print it in PETG. Don't use it on a hot bed above about 55 °C, because PLA softens.

Comments