From the Loftsmith community

Heat-set insert organizer

Sorts your heat-set inserts so the M3s stop hiding among the M5s. The lid has each size embossed on top, with a small notch at the front to lift it. Change the columns and rows to match how many sizes you keep.

2 parts · 54 g · 105 × 71 × 25 mm

Low rounded box with an orange lid embossed with M2, M2.5, M3, M4, M5 and M6
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • base · PLA · Flat on the bed, open side up
  • lid · PLA · Upside down, engraved face on the bed

    Plug ring points up

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
None

Assembly

  1. Drop inserts into the cells.
  2. Press the lid down until its ring seats in the rim.

Good to know

  • The lid is a push-fit with 0.3 mm clearance and nothing locks it. Adjust the Lid fit slider if it's too loose or tight.
  • The report still flags a few thin slivers in the pocket corners and engraved letters. They affect looks only, not strength.

Comments