From the Loftsmith community

AirBar lid clips (overhanging bar)

Holds an AirBar along the edge of a lid so the bar hangs just over the front. Two small clips grip the lid at each end, and a thin cable can run out the side. Change the lid thickness and the bar length to match your own setup.

2 parts · 16 g · 407 × 27 × 41 mm

Long flat panel with a small dark clip at each end holding a thin bar, a cable trailing off one side
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • clip-left · PLA · Standing on its flat bottom face, no supports

    Print flat bottom down.

  • clip-right · PLA · Standing on its flat bottom face, no supports

    Has the cable slot. Use the Cable side option to move the slot to the left clip.

Print settings

Layer height
0.2 mm
Walls
3
Infill
20%
Supports
None

Assembly

  1. Slide each clip onto the side edge of the lid, from the side.
  2. Press the AirBar down into both cradles until it snaps under the lip.
  3. Press the cable into the open slot from the top.

Good to know

  • Lid thickness (6 mm), AirBar size (15 × 9 mm), end gap (4 mm) and cable thickness are my estimates, not measured. Measure yours and set the sliders on Adjust before printing.
  • Neither the snap fit nor the grip has been tested on a real laptop. Print one clip first and try it on the lid.
  • The preview flags the AirBar and its cable overlapping. That's deliberate, because the cable leaves the bar's end.

Comments