From the Loftsmith community

1¼″ socket to 2″ spigot adapter

Joins a 1¼″ pipe to a 2″ hose or pipe, so two sizes that don't match can finally meet. The narrow end slips into a ribbed sleeve, and a flared collar marks where the wide spigot begins. Change the pipe size or the spigot length to suit your setup.

1 part · 43 g · 57 × 57 × 121 mm

Stepped round adapter with a ribbed socket end, a flared collar and a longer spigot on top
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • adapter · PLA · Spigot end down, no supports

Print settings

Layer height
0.2 mm
Walls
3
Infill
20%
Supports
none

Good to know

  • The spigot is 50.8 mm across, which matches a hose that is exactly 2″ on the inside. Measure your hose and change the Big spigot slider if it differs.
  • Nothing here seals the joints. Add a hose clamp, tape or sealant if you need an airtight or watertight fit. PLA softens at about 55 °C.
I printed this Remix

Comments