From the Loftsmith community

Shoe mount adapter for the Sony UWP-D21 receiver

Gets your Sony UWP-D21 receiver onto a camera shoe without it wobbling around. The receiver's foot slides into an open-ended slot on top, and a small T-shaped foot underneath slides into the shoe. Change the foot width and slot clearance for a snugger or looser fit.

1 part · 4 g · 24 × 30 × 18 mm

Small dark adapter with a open-ended slot on top and a T-shaped rail underneath
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • adapter · PLA · Foot flange down on the bed.

    The slot lips bridge about 3.5 mm. That is short enough to print without support.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None

Good to know

  • I assumed the receiver's foot is a standard 18.4 mm cold-shoe foot, but I haven't checked it against a real receiver. Print it, test the fit, and adjust the Slot clearance slider if it's tight or loose.
  • I haven't confirmed that this matches the real SMAD-P4 interface. If your camera has a Multi Interface shoe instead, tell me and I'll change the foot.
  • The M3 lock screw hole is a plain pilot hole, so thread a screw into it or tap it.
I printed this Remix

Comments