From the Loftsmith community

Pork Chop fuel pump trigger holder (crisp)

Holds a fuel pump trigger squeezed on so you can stand back while the tank fills. The flat tag has notches at the sides where the trigger and handle sit, with a small hole in one corner for a cord. The raised, colour-stepped logo is printed right into the top.

1 part · 28 g · 128 × 72 × 8 mm

Flat black tag with side notches and a raised red, white and blue Pork Chop the Trucker logo
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • holder · PLA (black, slot 1), with red, blue and · Flat on its back, logo facing up

    The logo layers print as part of the same object, so it's one print

Print settings

Layer height
0.2 mm (each 0.4 mm colour step is exactly 2 layers)
Walls
3
Infill
15%
Supports
None
Notes
AMS slots: 1 black (tag + first step), 2 red, 3 blue, 4 white. You'll have a prime tower and about 12 colour changes, all in the top 1.6 mm.

Good to know

  • I estimated the 60 mm trigger-to-handle gap, so measure your nozzle and set the 'Trigger-to-handle gap' slider before printing. Tiny paint splatters in the logo, anything under about 0.7 mm, were dropped because the nozzle can't print them. The small edges between colours are the 0.4 mm steps you as

Comments