From the Loftsmith community

S24 Ultra futuristic case

A snug shell for a Galaxy S24 Ultra, with a tall cutout around the camera lenses so nothing clips the photos. A small lip wraps the screen edge, and there's a gap along the side for the buttons. Change the phone size to dial in the fit.

1 part · 33 g · 84 × 168 × 11 mm

Dark phone case with a tall rounded camera cutout near one corner and a raised rim around the edge
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • case · PLA

    Print back-down, no supports.

  • accent · PLA

    Optional circuit-line inlay in a second colour (AMS). Turn it off with the Accent colour toggle for a single-colour print.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None
Notes
Print with the screen opening facing up.

Good to know

  • The camera window, the bottom opening and the button slot positions are estimates. No published source gave the USB-C position, so check them against your phone and adjust the sliders.
  • The phone goes in by flexing the lip over the frame (a snap-fit). The geometry check passes, but the snap is untested and there is no Use it animation. Try the lip slider if it's too tight or too loose.

Comments