From the Loftsmith community

Swirl Bic lighter sleeve

Dresses a plain Bic lighter in a red and white peppermint swirl, so yours stops looking like everyone else's at the bottom of a bag. The lighter slides into an open-topped sleeve, and the swirl is raised right into the walls. You can change the swirl arms and twist.

1 part · 12 g · 30 × 21 × 62 mm

Oval lighter sleeve with a red and white peppermint swirl pattern and an open top
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • sleeve · PETG · Upright, base down

    White body. No supports.

  • swirl · PETG · Printed inside the sleeve

    Red inlay on filament 2, flush with the surface. Print it all in one colour if you prefer.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None

Good to know

  • The Bic dimensions (25.3 x 15.5 x 63 mm) are typical values, not measured from your lighter. Check them on the Adjust tab before a long print.
  • Print the sleeve in white first. It takes about 25 min without the colour change. The red swirl inlay needs many filament changes.

Comments