From the Loftsmith Workshop
Sunflower pen and paint brush holder, 3-16 mm tools
Gives your pens and paint brushes a place to stand instead of rolling around the desk. The domed centre has a whole cluster of holes for different tool sizes, and the outer ones lean outward so handles fan out. Change the hole size to match your own tools.
1 part · 81 g · 157 × 158 × 25 mm
Ask for the sizes you want to tweak, e.g. “make the width adjustable”.
How to print it
Parts
- petal-base · PLA (yellow) · As modelled, flat on the bed
21 separate tapered petals (1.8 mm thick, reaching 25 mm past the seed head) and a foot ring the size of the seed head. About 26 g of the 84 g total at 2 walls/15%. PLA because it is a stiff indoor desk part with no heat or flex.
- seed-head · PLA (brown) · Printed in place on the petal base as one object (filament 2)
Domed seed head with all the holes and the 21 spiral grooves, about 55 g. With an AMS it is the second colour (about 1 filament change, about 0.9 g purge). Without one, change filament at the first layer above 1.8 mm.
Print settings
- Layer height
- 0.2 mm
- Walls
- 2
- Infill
- 15%
- Supports
- None (0.2% overhang in the build report, no supports estimated; outer holes lean 15° at the defaults, 25° at most)
- Notes
- Default figures from the build report: about 84 g and 1 h 43 min at 2 walls/15% infill, including the colour-change purge. For a sturdier print use 3 walls/15%: about 111 g, 2 h 15 min. The defaults are 158 mm across the petal tips and fit a 180 mm bed. 150 holes (249.6 mm across) or 16 mm tools (23
Assembly
- Measure your thickest tool across its widest point (a hex pencil across its corners) and set Tool diameter to it. Leave Hole clearance at 0.8 mm unless your printer makes holes tight.
- Set the Number of holes and the Outward lean (0 for straight holes), then check the size on the Footprint check.
- Print as one object: yellow for the petals, brown for the seed head (AMS slot 2, or a manual filament change at the first layer above 1.8 mm).
- No assembly: drop the tools into the holes.
Good to know
- Checked in the Loftsmith engine only; it has not been printed. Printed holes often come out 0.1-0.2 mm small, so raise Hole clearance if tools bind.
- Holes are not all the same depth because the dome is lower at the edge. Hole depth sets the shallowest hole (14 mm at the defaults, 12-35 mm on the slider); the centre holes are deeper (16 mm). For heavy or very long brushes, raise the depth.
- One hole size per print. Tools much thinner than the set diameter will lean more; the Tools drop in freely check shows the lean angle.
- The tip check treats each tool as a rod of the set diameter and length at 1.0 g/cm³ (roughly pen or pencil weight). Heavy steel tools such as scissors or large hex keys are not covered.
- Large settings get big and slow: 150 holes is 249.6 mm across and about 293 g / 5 h 36 min; 16 mm tools is 234.6 mm across and about 218 g / 4 h 9 min. Both need a 256 mm bed.
Comments