From the Loftsmith community

6× 3/8" hardline snap clip (no screws, flush ends)

Keeps six 3/8" tubes lying side by side in a neat row, with no screws and nothing to drill. Each tube presses into its own open-topped cradle and snaps in place. Change the tube size, the number of tubes or the spacing to match your run.

1 part · 7 g · 135 × 12 × 12 mm

Flat strip of six small open clips, each holding a pale blue tube running across it
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • clip · ASA

    Print on its side so the lips flex along the layers.

Print settings

Layer height
0.2 mm
Walls
3
Infill
20%
Supports
None
Notes
Print on its side with the enclosure closed.

Good to know

  • The report flags the tube push-in as blocked. The lips overlap the tube by about 0.8 mm per side on purpose, because that overlap is the snap.
  • This build keeps the ring size and fit of the version you printed. If you want it tighter or looser, use the Fit clearance slider and print a short 1–2 ring test strip first. Lip strain is about 2%, which is a calculation and not a test.
  • With no screws, the clip needs another way to be held down, such as double-sided tape or zip ties.
I printed this Remix

Comments