From the Loftsmith community

Euro pole to US 3/4" thread adaptor

Gets a European-threaded pole to screw into gear that expects a US 3/4" thread. One end is a socket for the pole, the other a threaded stud, with a ribbed round grip in the middle so you can twist it tight by hand. Change the pole thread size and pitch to match yours.

1 part · 16 g · 35 × 35 × 68 mm

Orange ribbed round grip with a threaded stud on top and a hollow socket underneath
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • adaptor · PLA · Upright, socket mouth on the bed

    4 walls, 25% infill

Print settings

Layer height
0.16 mm
Walls
4
Infill
20%
Supports
None needed, or a tiny amount under the bolt-head roof

Hardware

  • M6x25 steel bolt (8.8) · Head down in the socket, shank up through the stud as a core

Assembly

  1. Drop the M6 bolt in from the socket end, head first.
  2. Screw the pole into the socket; the pole tip keeps the bolt captive.
  3. Screw the tool onto the top stud.

Good to know

  • I guessed the pole thread (22.5 mm diameter, 4.5 mm pitch, 1 mm taper). Measure yours and set the sliders, then print a short test first.
  • The 3/4"-5 thread is a printed approximation. Adjust the US stud play slider if tools bind or wobble.
  • The core bolt is rated for a 10 N sideways push on a 150 mm tool. That is an estimate, not a physical test.
  • A short bridge over the bolt head may need a little support or ironing.

Comments