From the Loftsmith community

End cap for 3.6 mm pipe

Closes off the open end of a thin pipe so nothing gets in and nobody gets poked. The little cap slips over the end like a thimble, with a small gap so it goes on without a fight. Change the pipe size and the cap wall to match your own tube.

1 part · 0 g · 7 × 7 × 10 mm

Short dark cylindrical cap sitting on the end of a thin pale blue tube
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • pipe · PLA · Lying on its side

    Unchanged

  • cap · PLA · Closed end down, standing upright

    No supports; the chamfer is on the bed edge

Print settings

Layer height
0.12 mm
Walls
3
Infill
15%
Supports
None
Notes
Cap is small, so use slow small-layer cooling. Print a test cap first and adjust the fit gap slider if it's loose or tight.

Good to know

  • The 0.2 mm fit gap is untested. Print the cap and try it; use the Cap fit gap slider on Adjust to loosen or tighten it, or glue it on to make it permanent.
  • The build report's overhang warning on the pipe is only the curved underside of a round tube lying down; it prints without supports.

Comments