From the Loftsmith Workshop
Hidden radiator humidifier for 14-32 mm panel radiator gaps
Adds a little moisture to dry winter air without a gadget on your shelf. The tank hangs out of sight in the gap behind a panel radiator, held by a lip that hooks over the top edge. Change the gap width and tank length to suit your radiator.
1 part · 63 g · 177 × 26 × 98 mm
Loading the 3D view
Loading the 3D view
No adjustable sizes
Ask for the sizes you want to tweak, e.g. “make the width adjustable”.
How to print it
Parts
- tank · PETG · Upside down, rim flat on the bed (open top down); no supports
177 x 26 x 98 mm at the defaults, so it fits a 180 mm bed. The quantity follows the 'Tanks in a row' slider (1-3). PETG because it sits on a warm radiator for months; PLA softens near 50-55 °C.
Print settings
- Layer height
- 0.2 mm
- Walls
- 4 walls (makes the 1.6 mm walls solid perimeters for watertightness); the page default is 2
- Infill
- 20% (only the 3 mm rim and 2.4 mm floor have room for infill)
- Supports
- None. The floor closes with ~55° slopes onto a 5 mm bridge
- Notes
- Defaults: about 66 g and 1 h 37 min at 2 walls/15%; about 67 g and 1 h 39 min at 4 walls/20%. Print upside down on the rim. On smooth PEI, use glue stick or a release agent with PETG.
Assembly
- Measure your radiator first. Lift off the top grille and measure the narrowest gap between the two convector fin packs (Gap width). Then measure from the fin tops to the underside of the window sill (Free height above radiator). Set both sliders.
- Print the tank upside down on its rim in PETG with 4 walls. Fill it in the sink once and leave it on a paper towel for an hour to check for leaks before you use it on the radiator.
- Drop-in: lower the tank into the gap until the rim rests on the fin tops on both sides. To remove it, lift it by the two finger-loop ears and slide it toward the room.
- Hook-over: set Mount to hook-over. Set 'Hook-over: top edge thickness' to the edge it will hang from (8-60 mm) and Gap width to the space between that panel and the wall. Hook the bar over the edge so the tank hangs between the panel and the wall. Lift it 16 mm to unhook it.
- Fill to about 10 mm below the rim with a small jug or squeeze bottle. Empty, rinse and refill it at least once a week.
Good to know
- How much it raises room humidity was not modelled or checked. It is an open water tank, not a humidifier with a rated output and not a medical device.
- A slim tank holds far less than a ceramic hanging evaporator. Use a longer tank, a taller free height or 2-3 tanks in a row if you want more water. The Capacity check shows the figure for your settings.
- Standing water goes stale: empty, rinse and refill it at least weekly, and scrub it if a film forms.
- PETG is the right material here, but very hot radiators (flow temperatures well above 70 °C) can still soften it over time. Check that it isn't sagging after the first few weeks.
- Printed tanks can weep through layer gaps. Use 4 walls and do the sink test before you put it over the radiator.
- It is narrow, so it is not steady standing on a table when full. Fill it in place or hold it while filling.
- The fit check assumes the gap is parallel all the way down. If your fins narrow lower down, measure the narrowest point. The hook-over checks assume a square top edge.
Comments