From the Loftsmith community

Printable pen clicker

A little clicker for fidgety hands and long meetings. You press the orange plunger at the top and it springs back, and the dark twelve-sided body gives your fingers something solid to hold. Change the running gap if your printer needs a looser or tighter fit.

5 parts · 9 g · 18 × 18 × 56 mm

Tall dark twelve-sided cylinder with a short orange plunger poking out of the top
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • housing · PETG · Upside down, plunger-hole end on the bed

    No supports.

  • plunger · PETG · Stem down
  • rotor · PETG · Upright, flange down
  • spring · PETG · Lying flat

    100% infill, 2 walls.

  • cap · PETG · Flat, bigger face down

Print settings

Layer height
0.16 mm
Walls
3 (spring: 2 walls, 100% infill)
Infill
20%
Supports
None
Notes
All five parts can go on one plate, since the biggest is 18 × 18 mm. Print slowly for clean small teeth. The running gap is a slider (0.25 mm default); raise it to 0.3 if parts bind.

Assembly

  1. Drop the spring into the housing from the open end.
  2. Put the rotor in on top of the spring, then the plunger on top of the rotor. Its stem goes up through the top hole.
  3. Push the cap in, twist about 30° and let go. It drops into a small pocket that holds it locked.
  4. Press the plunger to test: first click latches it down, second click releases it.

Good to know

  • Not test-printed. The fits, the click force (about 3 N at full press) and the spring's life are calculated estimates, so print the housing, rotor and plunger first and check that they move freely.
  • The spring is thin (about 1 mm bars). The strain check passes at about 1.15% against about 2.3% yield for PETG, but it may fatigue after many clicks. The spring thickness slider goes up to 1.2 mm if you want it stiffer.
  • The housing still has 4 thin 0.5 mm ledges inside the bore. I couldn't remove them. They're small and a light pass with a hobby knife should clean them up.
  • The Use it animation reports the plunger and rotor overlapping the spring, because the animation doesn't squash the spring. I haven't proven that's a real clash.

Comments