From the Loftsmith Workshop
Monitor-top sticky note holder with clamp and pen cup
Gives your sticky notes a spot at eye level instead of all over the bezel. It clamps onto the top edge of your monitor, with a flat backboard for the pad and a little cup beside it that holds a pen. Change the pad size and the edge thickness to fit your own setup.
1 part · 38 g · 100 × 40 × 107 mm
Loading the 3D view
Loading the 3D view
No adjustable sizes
Ask for the sizes you want to tweak, e.g. “make the width adjustable”.
How to print it
Parts
- holder · PLA · Stand it on its left end (the pen cup end) on the bed so the clamp profile lies flat and layers run around the J-clamp. In this orientation it is about 107 x 40 mm on the bed and 100 mm tall at the de
One piece: J-clamp, pad ledge with thumb notch, leaning back plate and pen cup. PLA suits it because it is a stiff part used indoors at room temperature. Use PETG if the monitor's top gets warm (over about 50 °C).
Print settings
- Layer height
- 0.2 mm
- Walls
- 2 walls (default); 3 walls if you want a stiffer clamp
- Infill
- 15%
- Supports
- None
- Notes
- Default settings (2 walls, 15% infill): about 39 g and 1 h 5 min at the 76 mm pad size. With 3 walls and 15% infill: about 53 g and 1 h 29 min. Fits a 180 mm bed (A1 mini) at every slider setting; the largest (102 x 102 mm pad, 20 mm stack) is about 59 g and 1 h 34 min at 2 walls and 15% infill.
Assembly
- Measure your monitor's top edge front to back about 20 mm below the top, and set Monitor edge thickness to that number. The clamp adds 0.2 mm of clearance on each side.
- Measure how far the black bezel runs down from the top edge to the screen, and set Front lip drop to that or less so the lip never covers the picture.
- Set Back leg depth to how far down the back the leg can reach before the monitor's back curves away or meets buttons or vents.
- Set the pad width, height and stack height to your pad, and turn the pen cup on or off.
- Print it, then hook it straight down over the top edge with the pad side facing you.
- Slide the pad down the plate onto the ledge. The adhesive on its last sheet sticks to the plate, not to the monitor.
- Drop a pen into the cup on the left.
Good to know
- This holder sits on top of the monitor. It is not a side-mounted wing. It may cover a webcam mounted at the top, so put it to one side.
- The monitor edge thickness must be measured. The clamp has 0.2 mm of clearance per side and the back leg can spring open about 2.4 mm at the default 25 mm leg (0.9 mm at the shortest 15 mm leg). An edge more than that over the setting will not fit, and one much thinner will be loose.
- Monitors with a top bezel shallower than 4 mm, or a back that curves away right below the top edge, give the clamp little to grip. Gravity holds the holder on and the back leg only stops it tipping forward.
- Strength was estimated for a 5 N pull while peeling a note, not for leaning on it or hanging things from it. Fit and loads were checked in the engine, not on a printed part.
- The pen cup takes pens up to about 11.4 mm across. Thick markers will not fit.
- PLA softens at about 55 °C. If your monitor's top vents run hot, print it in PETG.
Comments