From the Loftsmith community

Skadis template

A flat plate with a grid of small holes, made for planning your Skadis board before you commit to a layout. It has two little hooks underneath that catch the board's slots, so it stays put while you work. Change the board thickness and the hook spacing to match your own panel.

1 part · 13 g · 50 × 80 × 16 mm

by manuel

Flat rounded plate with eight small holes, with two hooks underneath resting on a thin board
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • template · PLA

    Print deck face down, hooks pointing up. No supports needed.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None

Assembly

  1. Push the hooks through two slots 40 mm apart, with the plate flat on the board.
  2. Slide the plate down so the hook lips catch behind the board.

Good to know

  • The hook size is based on typical Skadis slots (5×15 mm, 5 mm board). The fit and grip are untested, so print it and try it on your board. Tweak the Slot width slider if it's loose or tight.
  • The lip is small and relies on friction, so keep loads light (well under 1 kg).

Comments