From the Loftsmith community

Galaxy S25 FE case with magnet ring

A snug shell for your Galaxy S25 FE, with a round ring on the back for a magnet. One tall opening lines up with the camera, and a side cutout leaves the buttons easy to reach. The lip around the screen is meant to hold the phone in.

1 part · 40 g · 80 × 165 × 13 mm

Phone case with a round ring on the back, a tall camera opening and a side cutout for buttons
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • case · PLA · Back face down, no supports.

    The ring pocket opens toward the phone side.

Print settings

Layer height
0.2 mm
Walls
2-3
Infill
15%
Supports
None
Notes
Print back-down. Fit the magnets after printing.

Good to know

  • Magnet ring size and position are estimates, so measure your ring and set the Magnet ring sliders on the Adjust tab before printing.
  • Glue the magnets into the pocket with matching polarity. I haven't tested the pull strength.
  • The back is thicker now (4.4 mm) to hold the pocket. The pocket and the phone fit are untested, so a quick test print is worthwhile.
  • Camera and button openings are estimated positions.

Comments