From the Loftsmith community

1/64 single car garage, flat roof

A tiny garage for the 1/64 car that never had a home. The front is open with a little ramp out, one side has a door and a four-pane window, and the flat roof lifts off so you can park a car inside. Change the car's width, length and height to fit yours.

2 parts · 63 g · 71 × 117 × 52 mm

Small flat-roofed garage with an open front, a side door, a four-pane window and a ramp
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • body · PLA

    Print slab-down. No supports.

  • roof · PLA

    Print base-down. The inside is hollow with a 45° ceiling, so no supports.

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
none

Assembly

  1. Set the roof onto the four corner pegs. It lifts straight off.

Good to know

  • The analyzer still flags thin edge lines. These are the small raised roof-edge and wall-top trim lips, and I left them in on purpose. The peg fit (0.3 mm clearance) and the car size are not tested on a real print, so adjust them with the sliders if needed.
I printed this Remix

Comments