From the Loftsmith community

Bone-handle 1-cup dog food scoop

Dishes out the same scoop of kibble every mealtime, without the guessing. The handle is a little bone with a rounded knob on the end, and the bowl has a paw print on the base. Change the capacity or the handle length to suit your dog and your bag.

1 part · 61 g · 87 × 211 × 54 mm

by Shipley3DEarly member

Yellow scoop with a squared bowl, a paw print on the base and a bone-shaped handle
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • scoop · PLA · Upright on the bowl floor, with the bone lying flat on the bed

    Filament slot 1 (honey yellow); no supports

  • paw accent · PLA · Prints in place inside the scoop floor

    Filament slot 2 (dark brown)

Print settings

Layer height
0.2 mm
Walls
3
Infill
20%
Supports
None
Notes
AMS slot 1: yellow PLA for the scoop. Slot 2: brown PLA for the paw. The colour only changes for a few layers, and the purge is about 5 g.

Good to know

  • PLA softens at around 55 °C, so wash it by hand in warm water. Don't put it in the dishwasher.
  • The strength figures come from calculations, not a physical test. Try bending a printed one by the knob before you rely on it.
  • Plain PLA prints aren't certified food-safe, but this is fine for dry kibble.
I printed this Remix

Comments