From the Loftsmith community

Chum Bullet

A little rocket you fill with bait and drop in the water so the scent drifts out. The body is covered in small teardrop holes, and a loop at the tip of the red nose cone takes a line. Change the hole size and the diameter to suit your bait.

2 parts · 59 g · 64 × 71 × 165 mm

Rocket-shaped holder with a red nose cone, tail fins and a body full of small teardrop holes
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • body · PLA · Standing on the tail and fins, open neck up.

    No supports.

  • nose-cap · PLA · Open thread end down, tip up.

    The thread flank has about 3% overhang. It is short, so it should print fine, but add tree supports if the slicer complains.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None expected

Good to know

  • The thread fit is untested. If the cap is tight or loose, change the Thread clearance slider (default 0.6 mm) and reprint the cap.
  • This is not tested in water. It has no weight, so add a sinker or clip it to your rig.
I printed this Remix

Comments