From the Loftsmith Workshop
Chord train whistle, 3-5 pipes, pick the root and chord
A little pipe whistle that plays a whole chord, one tube at a time. Five upright pipes step down in height, each with its note stamped on the base, so you can see which is which. Change the number of pipes or how wide they are to suit the chord you want.
1 part · 69 g · 124 × 34 × 156 mm
Loading the 3D view
Loading the 3D view
No adjustable sizes
Ask for the sizes you want to tweak, e.g. “make the width adjustable”.
How to print it
Parts
- whistle · PLA · Upright on its flat base, as modelled: pipes vertical, mouthpiece tongue flat on the bed at the right end. No supports.
One piece, 123.6 x 33.5 x 156.4 mm at the defaults; ~72 g and ~1 h 53 min at 2 walls / 15% infill. PLA because it is stiff and prints the labium edge and 1.2 mm windway cleanly; a whistle sees no heat or load.
Print settings
- Layer height
- 0.2 mm or finer (0.16 mm gives a cleaner windway and labium edge)
- Walls
- 2 walls (the page stats: ~72 g, ~1 h 53 min). 3 walls at 15% infill makes the pipes a little more solid: ~98 g, ~2 h 34 min.
- Infill
- 15%
- Supports
- None. The pyramid roofs inside each pipe, the teardrop air channels and the labium bevel are all at 45 degrees or steeper.
- Notes
- Keep the seam off the front face if your slicer allows it, so it does not land on the labium edges. Roots Bb4 to E5 fit a 180 mm printer at the default bore and correction; Gb4 to A4 make the tallest pipe up to about 240 mm and need a 256 mm build height.
Assembly
- No assembly: it prints as one piece.
- Look into each front mouth and the end of the mouthpiece. Clear any strings or blobs from the windway slits with a thin card or a 1 mm drill bit turned by hand. Do not cut or round the labium edge at the top of each mouth.
- Blow gently and steadily into the tongue at the right-hand end. All chambers sound together as the chord. Blowing harder raises the pitch.
- Check each note with a tuner app. If the notes read flat (low), raise the Mouth correction scale slider and reprint; if they read sharp, lower it.
Good to know
- Pitch is computed, not measured on a print; check each note with a tuner app and adjust the end-correction slider.
- The mouth correction is a lumped textbook approximation: a slot through the wall plus a flanged-aperture correction on each side. Breath pressure and room temperature also move the pitch, and one scale slider shifts every chamber by the same length, so a print can still need individual pipes trimmed
- Roots Gb4 to A4 make pipes taller than 180 mm and need a 256 mm build height.
- It is loud and shrill at close range. It is a desk toy and gift for adults, not a children's toy, and it has small openings.
- Mouth-blown only. It has no fittings for a compressor or air line and is not meant for pressurised air.
Comments