From the Loftsmith community

Rebel 500 key cover

A fresh shell for a worn or cracked key head, so it stops looking tired in your pocket. Two halves close around the key, the blade pokes out through a slot at the narrow end, and a small screw holds it shut. Change the head size and blade slot to match your key.

2 parts · 11 g · 38 × 61 × 15 mm

Red teardrop-shaped key cover with black base, two holes at the top and a blade slot at the bottom
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • cover-bottom · PLA · Outer face down on the bed

    Press an M3 nut into the hex pocket

  • cover-top · PLA · Outer face down on the bed

    Has the recessed seat for the screw head

Print settings

Layer height
0.2 mm
Walls
3
Infill
20%
Supports
None
Notes
Print both halves together on one plate

Hardware

  • M3x10 socket head screw
  • M3 hex nut · A plain nut fits the 2.4 mm pocket. A nylock is too tall for it

Assembly

  1. Press the M3 nut into the hex pocket on the black half's outer face.
  2. Lay the key in the black half with the blade going out the bottom slot.
  3. Put the red half on top and tighten the M3x10 screw with a 2.5 mm hex key until it's snug. Don't overtighten it.
  4. Thread your keyring through the hole in the tip.

Good to know

  • I used typical Honda key sizes (33 × 36 × 9.5 mm head), not measurements of your key. Measure yours and set the sliders before you print. If the key rattles, lower Fit clearance; if it won't close, raise it.
  • PLA softens at about 55 °C, so don't leave the key on a dashboard in the sun. PETG would handle the heat better.

Comments