From the Loftsmith community

GNCC camera mount for P1S screen

Holds a small camera right above your P1S screen so you can watch your prints. A dark clip grips the edge of the screen housing, and a hinged arm lifts a flat orange platform up to hold the camera. Change the housing thickness and camera width to match yours.

2 parts · 14 g · 48 × 34 × 108 mm

Dark clip gripping a flat edge, with a hinged orange arm holding a square camera platform above it
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • clip · PLA · On its side, so the C-shape lies flat

    Press an M4 nut into the trap

  • arm · PLA · Pad face down

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
Only if the ear knuckles sag

Hardware

  • M4 x 25 bolt · Tighten for the tilt friction you want
  • M4 nut
  • 1/4"-20 screw, ~12 mm

Assembly

  1. Press the M4 nut into the trap on one ear of the clip.
  2. Slide the arm knuckle between the ears and push the M4 bolt through.
  3. Screw the camera onto the pad from below with the 1/4" screw.
  4. Push the clip down over the top edge of the screen housing.

Good to know

  • The report flags a 48 mm³ overlap between the clip and the housing. It is deliberate: the two grip bumps press 0.4 mm into the housing. Lower the Clip grip squeeze slider if it is too tight.
  • The housing thickness (12 mm) is a guess. The ear knuckles may need about 1 g of support. Nothing has been test-printed.

Comments