From the Loftsmith community

IKEA Besta 80mm fan duct

Gives the warm air from an 80mm fan somewhere useful to go inside an IKEA Besta cabinet. A small square flange with screw holes sits on the fan, then the round duct bends and fans out into a wide, flat opening. Change the outlet length and width to match your gap.

1 part · 65 g · 214 × 106 × 55 mm

by Viktor

Blue air duct with a square fan flange that bends and widens into a long flat outlet
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • duct · PLA · Hex mesh face flat on the bed, fan flange on top

    Needs supports under the bend and flange.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
Yes, tree/normal supports under the bend and flange (the slicer will place them)
Notes
The hex mesh face sits on the bed, so its cells print straight up.

Hardware

  • 4 × M4 screws for the fan (typically the fan's own, ~25-30 mm) · Holes are 4.4 mm clearance; check your fan's screw length.

Good to know

  • The slicer needs supports under the bend; the report's estimate is up to about 100 g extra, so expect it to be heavy and slow.
  • The 10 mm corner radius, the 48 mm bend radius, 9 mm hex cells and the 36 mm width being the outside size are my assumptions; change them on the Adjust tab.
  • I haven't tested the airflow or fan screw fit physically; check your fan's hole spacing.

Comments