From the Loftsmith community

A mounting plate for a Raspberry Pi 5 that uses 58 x 49 mm M

Gives a Raspberry Pi 5 a flat base to screw down to, so it stops sliding around your desk or shelf. Four standoffs lift the board off the plate, and a ring of small vents sits under the chip. Change the hole spacing to match your own board.

1 part · 21 g · 110 × 80 × 9 mm

Flat rectangular plate with four tall pegs rising from the corners and a vent pattern in the middle
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Comments