From the Loftsmith community

Small pipe 3.6 × 1.2 × 105

A thin hollow tube for the jobs that need a little channel: a spacer, a sleeve over a wire, a small axle bushing. A narrow bore runs the whole length. Change the outer width, the bore or the length to match your project.

1 part · 1 g · 4 × 4 × 105 mm

Long, thin hollow rod standing upright with a tiny hole through its centre
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • pipe · PLA · Lying on its side

    No supports; the report's overhang warning is just the curve of the underside of a round tube

Print settings

Layer height
0.12 mm
Walls
3
Infill
15%
Supports
None
Notes
A thin 105 mm tube can flex while printing, so print slowly. A thin brim helps it stick.

Good to know

  • The 6-minute time in the report looks too short for 105 mm of tube; I'd expect about 30 minutes, so treat it as a rough guess.
  • A tube this thin and long is fairly bendy. Check that a 1.2 mm wire slides the full length; if not, raise the Hole allowance slider.

Comments