From the Loftsmith community

Rod butt cup for 20×3 flat bar

A one-piece PLA butt cup for a 25 mm rod butt. The 26 mm bore is 40 mm deep and has a flared, rolled rim. It blends down into a 40 mm deep socket (20.5 × 3.5 mm) that slides onto your 20 × 3 mm flat bar at a right angle to the cup opening. One M5 bolt through the bar locks it, with the nut trapped in the cup. It is 34 mm wide and about 85 mm tall.

1 part · 45 g · 75 × 51 × 72 mm

Teal cup with a flared mouth and small side holes, joined to a flat bar and a clear rod
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • butt-cup · PLA · Upright, socket opening on the bed. No supports.

    Bolt pocket and nut trap print as small teardrop holes.

Print settings

Layer height
0.2 mm
Walls
3
Infill
20%
Supports
None

Hardware

  • M5 socket-head bolt · About 25 mm long. Check it clears the nut when the bar is in.
  • M5 hex nut · Sits in the hex trap on the -Y face.

Assembly

  1. Drill a 5.5 mm hole through the bar's 20 mm width, 16 mm from its end.
  2. Slide the bar into the socket until it stops, then line up the holes.
  3. Drop the M5 nut into its pocket, then push the bolt in from the head side and tighten.
  4. Drop the rod butt into the cup.

Good to know

  • The fit is untested. The socket has 0.5 mm of clearance, so adjust the Bar fit clearance slider if it is tight or loose.
  • The bolt hole is at 16 mm from the bar end. It must be drilled in your bar to match.

Comments