From the Loftsmith community
Roller card embosser
A roller business-card embosser in PETG. You slide a card across the feed table and turn the knob. A raised male roller and a matching recessed female roller press the pattern into the card. Gears keep the two rollers lined up. The roller sleeves are replaceable. The Roller pattern choice on Adjust switches between diamonds, dots, ribs and waves, and Emboss depth sets the relief. Your marked area is fixed: the upper shaft now has a round retaining head on the knob side. The head stops it sliding inward, and the press-on gear stops it sliding out. Everything is printed with friction fits, with
9 parts · 92 g · 94 × 92 × 68 mm
Ask for the sizes you want to tweak, e.g. “make the width adjustable”.
How to print it
Parts
- base · PETG · Flat on the slab, cheeks up
- cap · PETG · Bar side down, pegs up (rotate 180°)
- axle-upper · PETG · Lying on its D flat
Has the retaining head
- axle-lower · PETG · Lying on its D flat
- roller-male · PETG · Standing on its end
- roller-female · PETG · Standing on its end
- gear-male · PETG · Flat
- gear-female · PETG · Flat
- knob · PETG · Flat
Print settings
- Layer height
- 0.16–0.2 mm (0.12 mm for the rollers for crisper texture)
- Walls
- 4
- Infill
- 25%
- Supports
- None expected; check the roller sleeves in preview
Assembly
- Slide each shaft in through its roller sleeve, from the knob side, between the cheeks. The upper shaft goes in until its head stops 0.2 mm outside the cheek.
- Press the lower gear (tooth pointing at the nip) and the upper gear (gap at the nip) onto the D flats on the gear side.
- Press the knob onto the lower shaft's D flat.
- Drop the cap pegs into the slots. To change patterns, lift the cap, pull the gears and knob, slide the shafts out, and lift the rollers out upper one first.
Good to know
- I haven't tested the press fits, gear meshing or real emboss force. Print the two rollers, gears and shafts first and use the Press-fit clearance slider if they're too tight or loose.
- The textured roller sleeves show small overhang warnings from the pattern itself. They print standing on their ends and should need little or no support, but check your slicer preview.
- The lower shaft's route in the assembly check wasn't fully validated before the time budget ran out. Test the assembly order by hand.
Comments